Cutting Miter Joints in Small Moldings
Video Demonstration
For cutting miter joints in small moldings, we advise placing a piece of 2"x2" timber against the back of 'fence' of the Magic Mitre and place it in a position where its end is very close to the saw cutting line.
This will provide you with a support when cutting small moldings and prevent them from moving when cutting right up to the saw cut line.
You can then follow the standard instructions for cutting miter joints, applying this addiditonal procedure.
Please Note
These TOP TIPS for cutting miter joints are provided as a service from MML (QS) Ltd. The information is intended to help with the cutting and fitting of moldings around the house with the use of the "Magic Mitre" product.
MML (QS) Ltd assumes no liability for omissions, errors or the outcome of any project. The reader and user of the product must always exercise all reasonable caution and follow all applicable codes and regulations and the safety instruction.